Test GET electronics with internal pulsers

1. run GetController and open test recorded as test

the configurations are listed below,

ECC: 127.0.0.1: 46002
DAQ: 192.168.50.1:46005
Target: 192.168.40.81:46001

Hardware: hardwareDescription_fullCoBoStandAlone.xcfg
Conditions: configure-pulser.xcfg
Data: /home/daq/DAQ/example_pulser/data

where 192.168.50.1 is the network card connecting to the data port of the Cobo, 192.168.40.81 is the ip of the control part of Cobo

2. open the vmplayer and turn on windows 10. Open the Winner Power Supply application (making sure the usb channel of the power supply is connected to Windows 10, not ubuntu)

The output of the power supply is set to be 3.6 V.

3. Open one terminal, type getEccServer
Open another terminal, type GetEccController

Also in the configure-pulser.xcfg file, the Setup->Node->Instance[*]->Asad[?]->Control->isActive needs to be set correctly for connected AsAd. If not the program will not run.

then, simply sequentially click Load Hw, Configure, and Start. When finish click stop and reset.

4. To view the offline data, you can use cobo-frame-viewer .

Comments are closed.